JUAL ROCKFORD FOSGATE DSM 4080 & DSM 100

[RocketCable]

<div id="post_message_5679792">

WTS



ROCKFORD FOSGATE



PUNCH DSM 4080 AND DSM 100



SPECIFICATIONS



PUNCH 4080DSM

Dynamic Power Rating (IHF-202 Standard) - Measured at 14.4 Volts1

Bridged into a 4Ω Load 220 Watts x 2

Per channel into a 2Ω Load 100 Watts x 4

Per channel into a 4Ω Load 60 Watts x 4

Continuous Power Rating (IASCA Standard)

RMS continuous power per channel, all channels 40 Watts

driven into a 4Ω load from 20 to 20,000 Hz, with less ( @ 13.8

than 0.05% Total Harmonic Distortion (THD) battery volts) battery volts)

RMS continuous power per channel, all channels 80 Wattls

driven into a 2Ω load from 20 to 20,000 Hz, with less ( @ 12.6 ( @ 13.8

than 0.1% Total Harmonic Distortion (THD) battery volts) battery volts)

RMS continuous power bridged into a 4Ω load from160 Watts

20 to 20,000 Hz, with less than 0.1% Total Harmonic ( @ 12.6 ( @ 13.8

Distortion (THD) battery volts) battery volts)

Signal-to-Noise Ratio Over 100dB A-weighted

Factory Default Crossover Point 100 Hz - Selectable with optional Module Cards

Crossover Alignment Butterworth

Dimensions

9-5/8" (24.4cm) W

13-5/8" (34.6cm) L

2-5/8" ( 6.6cm) H

Bandwidth 15Hz to 100kHz

Damping Factor @ 4Ω At output connector - Over 150

Frequency Response 20Hz to 20kHz ±1dB / 10Hz to 100kHz -3dB

Crossover 12dB/octave with selectable high pass, low pass and full range

via interchangeable Module Cards

Slew Factor Over 5

IM Distortion (IHF) Less than 0.05%

Input Gain Variable from 40dB to 14dB (200mV - 2 Volt)

The above figures are factory preset and are correct

for 500 mV rated source units.

Protection Internal analog-computer output protection circuitry limits power in case of

overload. Thermal switch shuts down the amplifier in case of overheating.

B+ Fuse Size 30 Amps 50 Amps

(External to Amplifier)

Fuse Type ATC AGU

Equalization Bass: +18dB Maximum at 45Hz

Treble: +12dB Maximum at 20kHz

Input Impedance 20k ohms

DSM 100

Specifications:



Measured at 12.6 battery volts



50 Watts RMS per channel into 4 ohms

100 Watts RMS per channel into 2 ohms

200 Watts RMS mono into 4 ohms

Less than .05% total Harmonic Distortion from 20-20,000 Hz





Specifications:



Measured at 14.4 battery volts



110 Watts RMS per channel into 4 ohms

200 Watts RMS per channel into 2 ohms

420 Watts RMS mono into 4 ohms

Less than .05% total Harmonic Distortion into 4 ohms and less than .10% into 2 ohms from 20-20,000 Hz



























08161998078